Many home owners find that the installed switch is invalid after home decoration. What is the reason and what is the solution? Let's find out:
Reasons for the failure of the decoration switch: The reasons for the failure of the switch during decoration are nothing more than the following three situations:
1. The installation was not disassembled as required, mainly when the outer button was removed by one-sided prying, which caused the inner button to pop out from the rear cover and could not be reinstalled.
2. If the wall surface is uneven and the panel screws are over-tightened during installation, the panel will be deformed and the size of the window will change.
3. The switch is not smooth due to the paint entering the inside of the switch.
In view of the above reasons that lead to the failure of the decoration switch, the corresponding solutions are summarized for everyone:
1. Disassemble according to the method in the manual, and poke outward with a little force from the panel mounting hole. When there is a certain gap between the outer button and the panel, then pry outward simultaneously on both sides of the outer button.
2. Since the panel is made of thermoplastic, although it has a certain degree of rigidity, it is easy to deform if the screws are too tight. Therefore, the principle of fixing the panel should not be loose.
3. After the wall is painted, install the switch or cover the switch with a plastic film when painting.
English
中文简体
